LOCATION:Home > NEWS > Company News >
NEWS CATEGORY
HOT PRODUCT

Environmental requirement of Fiber laser cutting machine

2020-09-01 08:24:59

Although the product performance of laser cutting machine itself is very good, but the operating environment must be up to the standard to give full play to the good performance, otherwise once it runs in the place that does not meet its working conditions, it will not only affect the work efficiency of the equipment, but also cause loss impact.So what aspects should be paid attention to in the operating environment of laser cutting machine?

Number one: Temperature

Laser cutting machine is generally a constant temperature environment, only under the constant temperature condition, to ensure the normal operation of the equipment and the processing accuracy of the equipment.The working temperature of the semiconductor in the cutting machine is required to be below 40~45℃. When the room temperature reaches 35℃, the internal temperature of the electric cabinet can reach above 40℃. When the room temperature is too high, the failure rate of the NUMERICAL control system will increase.

Number two: Humidity

The relative humidity of cutting machine should be less than 75%.Because in the high temperature and high humidity cutting machine after power off, the water molecules in the air will produce condensation on the power supply or drive device circuit board, when the condensation on the circuit board will cause a short circuit, thus causing machine failure.

Third point: voltage

The power supply voltage fluctuates greatly, which may cause the laser cutting machine undervoltage or overvoltage alarm, and even the loss of data.Therefore, the voltage is generally required to be within ±10% of the rated operating value.If the voltage is unstable, it is recommended to provide a stable power supply.

Fourth: Dust prevention

In the long-term cutting process, if there is no good dust removal, conductive dust will affect the operator's health. In addition, if the electric cabinet is not properly handled, dust will enter the electric cabinet and deposit on the circuit board or module, which will lead to damage of electrical components, especially high voltage components.So the equipment should be equipped with good dust removal equipment when it works.

No. 5: Ground wire

The normal operation of the equipment shall be well grounded.

Sixth point: Illumination

Avoid direct sunlight to laser cutting machine, indoor should be equipped with good lighting equipment.

Number seven: Ventilation

We mentioned humidity and conductive dust in the above working conditions, ventilation is a very natural method of elimination, effective ventilation can better ensure the good operation of the cutting machine and the operator's health.

Therefore, when you install the laser cutting machine, you must install it in a place that conforms to the above working conditions, so as to better avoid the interference of some environmental factors and other external factors, so that the cutting machine equipment can work well.


WECHAT BUSINESS CARD
CONTACT

HOT-LINE:+86 183-3309-1632

E-MAIL:18333091632@139.com

ADD :West Side of Donggu Road, Jiaohe Town, Botou City, Cangzhou City, Hebei Province, China

Copyright © 2019-2020 www.guohonglaser.com. All Rights Reserved chiye